CLIVET LIGHT Commercial Duct 2 Manuel page 83

Installation
4 Cut the cable on the 5-pin connector side.
connector
10 pin
5 Fasten the protective PVC cover on the bottom of the
remote display.
6 Connect the 10-pin connector of the remote display
to the CN10 connector of the main board. Use the 2m
extension lead provided if necessary.
CN10
WARNING
The remote display must be fixed in a position
that allows it to receive the signal from the
remote control without interference.
connector
5 pin
Fig. 46
Fig. 47
Fig. 48
33