Assembly Instructions - Kobalt SGY-CMI Mode D'emploi

A SSEMB LY INSTRUCTIONS
Note Fasteners should only be tightened after final ali
achieved.
1. Attach bottom casting (A) to rear leg (D) using two M8 × 45
bolts (EE) and two M8 nuts (HH).
Attach rear leg cross member (E) to rear leg (D) using two
M8 × 60 bolts (FF) and two M8 nuts (HH).
DO NOT COMPLETELY TIGHTEN.
HARDWARE USED
EE M8 × 45mm Bolt 2
M8 × 60mm Bolt 2
FF
M8 Nut 4
HH
2. Slide pivot pin (L) through bottom casting (A) and front
legs (H). Insert cotter pins (JJ) into pivot pin (L).
Be sure to secure cotter pins (JJ) properly into pivot pin (L)
before moving onto next step.
HARDWARE USED
JJ Cotter Pin 2
3. Assemble lower frame support (I) to front legs (H)
using two M8 x 45 mm bolts (EE) and M8 nuts (HH).
Assemble lower frame support (I) to rear leg (D) using
M8 x 60 mm bolt (FF) and M8 nut (HH).
DO NOT COMPLETELY TIGHTEN.
HARDWARE USED
M8 × 45mm Bolt
EE 2
M8 × 60mm Bolt 1
FF
M8 Nut
HH 3
4. Assemble front cover (K) to front legs (H) using four
M8 × 40 mm bolts (DD) and M8 nuts (HH).
HARDWARE USED
DD M8 × 40mm Bolt 4
M8 Nut 4
HH
gnment
7