Hardware Contents; Safety Information - Kobalt SGY-CMI Mode D'emploi

HARDWARE CONTENTS

Part Description Quantity
M10 Nut
AA
M10 Flat
BB
Washer
Shoulder Bolt
CC
M8 × 40mm Bolt
DD
M8 × 45mm Bolt
EE
M8 × 60mm Bolt
FF
Motor Shaft Pin
GG
M8 Nut
HH
End Cap
II
(Pre-installed)

SAFETY INFORMATION

Follow owner's manual to ensure proper assembly of mixer, using the parts list in conjunction with
assembly procedures.
• Carefully read the caution and warning messages.
• Review these instructions before operating mixer. Retain for future reference.
• All bolts should be fastened with the nuts facing toward the center of the mixer.
• Do not tighten fasteners until final alignment is achieved.
• Parts may have sharp edges. Gloves should be worn. Use caution when assembling.
• Safety glasses should be worn while operating this mixer.
• All wiring, electrical connections, and system grounding must comply with the National
Electrical Code (NEC) and with any local codes and ordinances. Contact a local licensed
electrician for further information.
• Do not expose to rain, store indoors.
• A ground fault interrupter (GFI) protected circuit is recommended for all outdoor electrical
devices.
• Keep motor operating area as dry as possible.
• Always disconnect the power before servicing.
Picture
2
2
2
5
6
3
1
18
2
CAUTION - ALWAYS START MIXER EMPTY
WARNING - ELECTRICAL PRECAUTIONS
WARNING - RISK OF ELECTRICAL SHOCK
Description
Part
Cotter Pin
JJ
M8 U-Bolt
KK
Retaining Clip
LL
(Pre-installed)
Retaining Clip
Handle
MM
(Pre-installed)
M6 Nut
NN
(Pre-installed)
M6 Flat
Washer
OO
(Pre-installed)
M6 Spring
PP
Washer
(Pre-installed)
4
Quantity Picture
3
2
1
1
4
4
4