Brandt BFL862YNW Manuel D'instructions page 53

Troubleshooting
Caution! Before troubleshooting, disconnect the power supply. Only a qualified electrician of
competent person must do the troubleshooting that is not in this manual.
Important! There are some sounds during normal use (compressor, refrigerant circulation).
Problem
Appliance does not
work
Appliance cools too
much
The food is too
warm
Unusual noises
If the malfunction shows again, contact the Service Center.
These data are necessary to help you quickly and correctly. Write the necessary data here, refer
to the rating plate.
Possible cause
Mains plug is not plugged in or
is loose
Fuse has blown or is defective
Socket is defective
Temperature is set too cold or
the appliance runs at Super
modes.
Temperature is not properly
adjusted.
Door was open for an extended
period.
A large quantity of warm food
was placed in the appliance
within the last 24 hours.
The appliance is near a heat
source.
Appliance is not level.
The appliance is touching the
wall or other objects.
A component, e.g. a pipe, on
the rear of the appliance is
touching another part of the
appliance or the wall.
Solution
Insert mains plug.
Check fuse, replace if necessary.
Mains malfunctions are to be corrected
by an electrician.
Turn the temperature regulator to a
warmer setting temporarily.
Please look in the initial Temperature
Setting section.
Open the door only as long as
necessary.
Turn the temperature regulation to a
colder setting temporarily.
Please look in the installation location
section.
Re-adjust the feet.
Move the appliance slightly.
If necessary, carefully bend the
component out of the way.
53