2 Technical characteristics
Box: plastic, polycarbonate / ABS, polymethylmethacrylate (PMMA).
Class of protection: IP 20 / DIN 40050
Ambient temperature: 0 ... 40 °C
Dimensions: 172 x 110 x 46 mm
Type of mounting: wall-mounted, included in Dietrisol QUADRO, possible
integration in an electricity distribution board
Display: multifunction alphanumeric LCD, with 8 pictograms, 2 2-character
text fields and 2 2-colour 7-segment 4-character digital LED fields
Controls: via 3 keys on the front panel
1 Installation
The device must be installed inside the building in a dry place. For perfect
operation the device must also be installed in a location free from powerful
electromagnetic fields. It must be possible for the regulator to be isolated
from the mains by a circuit breaker that provides at least a 3 mm gap
between all the poles or by a circuit breaker that conforms to installation
standards. When installing, take care to fit the power supply cable and the
sensor wires separately.
Before dismantling anything, take care to disconnect the unit from
the mains.
1. Mark the mounting point on the wall and fit the dowel supplied and the
matching screw without tightening it.
2. Remove the Phillips screw from the cover and separate the cover from
the unit by pulling it downwards.
3. Hang the unit from the upper mounting point. Mark the lower mounting
point on the wall (160 mm drilling template), see the back of the base
frame, then fit the lower dowel.
4. Hang the unit by the top and tighten the lower screw.
19/07/05 - 94858821 - 8980-4231E
Storage temperature: -20 ... +70 °C
Range of measurement: -40 ... +250 °C
Inputs: 3 Pt1000 temperature sensors
Outputs: 3 relay outputs, including 2 semiconductor relays for speed control
and 1 standard relay
Max. current: 4 A
Power supply: 210 ... 250 V (AC), 50 ... 60 Hz
Power consumption: approx. 2 VA
Installation
1
Top cover
2
Alphanumeric LCD display
3
Control keys
4
Terminal blocks
5
Base
6
Cable clamps
7
Sub-cover
8
Cover
9
LED
Diemasol Ci
27