Benelli BN600R Manuel D'utilisateur page 92

UK
If the fl uid level in the tank is close to
minimum, make a visual check of brake
pad wear. If the pads are not worn, there
may be a leak in the hydraulic circuit.
Contact a Benelli assistance centre for
an inspection as soon as possible.
IMPORTANT NOTICE:
Incorrect maintenance may cause a
brake capacity reduction.
Respect the following precautions:
• Insuffi cient brake fl uid may cause
air to enter the brake circuit, caus-
ing a reduction in brake perfor-
mance.
• Clean the fi ller cap before removing
it. Only use DOT 4 brake fl uid
• Only use the prescribed brake fl uid,
as per the specifi cations. Any other
type could cause the rubber seals
to deteriorate, leading to leaks.
• Top up with the same type of brake
fl uid. Adding a different type of
brake fl uid from DOT 4 may cause
a noxious reaction.
• Do not allow water or dust to enter
the brake fl uid tank while refi lling.
Brake fl uid can damage painted surfac-
es or plastic parts. Clean
any spilled liquids immediately.
IMPORTANT NOTICE:
Since brake pads become worn, it is
normal for the fl uid level in the tank to
drop gradually. If the brake fl uid level
is low it is possible that the brake pads
are worn and/or that there is a leak in
the brake circuit; therefore, make sure to
check the brake pads for wear and to
look for leaks in the brake circuit.
Topping up and replacing the
disc brake fl uid
Contact an authorised Benelli mechanic.
92
BN600R
Check the wear of the brake
pads
Make a visual check of brake pad wear
The pads are to be replaced if the wear
indicators
can no longer be seen. In this case
contact an authorised Benelli mechanic.
BRAKE PADS
INDICATIONS OF
WEAR
DISC BRAKES