ECOVACS Deebot OZMO T8 AIVI Manuel D'instructions page 26

No. Malfunction
DEEBOT misses cleaning
7 spots to be cleaned, or repeats
cleaning the area cleaned�
DEEBOT is making too much
8
noise when cleaning�
AIVI Visual Detection Sensor
9
cannot recognize objects�
26
EN
Possible Causes
The cleaning cycle is interfered by small
objects or barriers on the floor�
DEEBOT is working on slippery polished
floors�
DEEBOT is unable to reach certain areas
blocked by furniture or barriers�
The TrueMapping Distance Sensor is
blocked�
DEEBOT is tangled or blocked with debris�
The cleaning area is not well illuminated�
AIVI Visual Detection Sensor lens is dirty or
blocked�
The objects are too close to the AIVI Visual
Detection Sensor�
Solutions
Remove power cords and small objects from the floor
to ensure cleaning efficiency� DEEBOT will automatically
clean the area missed, please avoid moving DEEBOT
manually or block the path during the cleaning cycle�
Make sure the floor wax is dried before DEEBOT starts
cleaning�
Tidy up the area to be cleaned by putting furniture and
small objects in their proper place�
Remove the objects that are blocking the TrueMapping
Distance Sensor�
Clean DEEBOT as described in section 4 Maintenance
and restart� If the trouble persists, please contact
Customer Care�
Smart Recognition requires sufficient lighting� Please
make sure the areas to be cleaned are well illuminated�
Clean the lens with a clean soft cloth, and make sure
the sensor is not blocked� Avoid using any detergent or
cleaning spray while cleaning�
This is normal� The optimal distance of object
identification for AIVI Visual Detection Sensor is 50
cm(19�7 inches)�