Renkforce RSD-1802 SD Mode D'emploi page 45

Button functions
BND/AMS button (11)
Briefly push this button to select the band range of the radio unit.
There are 3 FM ranges and one AM range:
F1 > F2 > F3 > MW
On each of the four band ranges, 6 stations can be stored on the station button 1-6 (15).
Keep this button pushed to activate automatic station search. SEARCH flashes in the display.
All stations that can be received well are automatically stored for the station buttons 1-6 (15).
After this procedure, the stored stations are played for a few seconds.
44 (8) and 66 (1) buttons
With these buttons the receiving frequency can be changed to adjust stations in radio operation.
Briefly pushing a button starts the automatic station search (display shows SEARCH).
The auto-scan only stops at the next station that can be received well.
By pushing a button longer, you activate manual station scan.
The display shows MANUAL.
In this mode, the frequency is changed until you release the corresponding button again. Brief pushes of
this button changes the frequency step by step.
If buttons are not pushed for an extended period of time, the devices switches back to automatic
station search. The display shows AUTO.
Station buttons 1-6 (15)
If you briefly push these buttons, you can select a station you have pre-set.
If you want to store a station you are listening to, simply push the desired button for more than 1 second.
Every one of the three FM ranges (F1-3) and the AM reception range (MW) has six station but-
tons. Therefore you can assign 24 station buttons.
45