Connection Of The Speakers And The Power Supply - Renkforce RSD-1802 SD Mode D'emploi

d) Connection of the Speakers and the Power Supply
Vehicles equipped with an ISO plug can be connected directly to the ISO connection terminal if the plug
assignment is the same (please check beforehand!). If the plug assignment differs, use a vehicle-specific
adapter from a vendor for connection.
Please refer to the following figures for the contact assignment of the ISO connection socket of the SD
tuner.
Please ask your car dealer for the respective assignment of your vehicle system plug.
System connector B (speaker connection)
(1) Speaker rear right (+)
(2) Speaker rear right (-)
(3) Speaker front right (+)
(4) Speaker front right (-)
(5) Speaker front left (+)
(6) Speaker front left (-)
(7) Speaker rear left (+)
(8) Speaker rear left (-)
System plug A (power supply)
(1) (Not assigned)
(2) (Not assigned)
(3) (Not assigned)
(4) Continuous current +12V
(5) Aerial control output
(6) (Not assigned)
(7) Ignition +12V
(8) Ground
38