Memory Function - Biosynex MedicAid 858754 Manuel

MEMORY FUNCTION

Recall measurements in the Memory:
You can recall up to 60 total measurements in the
memory, plus an average of the 3 last measurements
saved in the memory to share them with your doctor
or a quali ed health care professional.
1. Press and release the «MEMORY» button. The
device will then show the average of the last 3 saved
measurements.
2. Continue to push the «MEMORY» button to see
the previously saved measurements. The measure-
ments will appear on the screen from the most recent
to the oldest; the number of memory will appear on
the lower left corner.
Notice-Medicaid-tensio-858754-v1-042017-r1.indd 32
Press the
«MEMORY»
button.
3. All the results of a given measurement will show,
including the measurement results, the heart rate, the
hypertension indicator and the timestamp.
4. When the number of readings surpasses 60, the
oldest data will be replaced by the new recording.
5. Press the Power button to turn off the blood
pressure monitor at any time while reading saved
measurements
Erasing Measurements from the Memory:
From the turned off screen,
hold the «MEMORY» button
down until the screen
shows CLr. This indicates
that all measurements have
been erased.
32
18/04/2017 15:24:37