Dometic B29G Instructions De Montage Et De Service page 17

Wine Refrigerators
NOTICE!
• Do not place the wine refrigerator in direct sunlight or in the vicinity of strong heat sources (heating appliances,
ovens, etc.).
• Only locate the wine refrigerator indoors, never outside.
• Check that the voltage specification on the type plate is the same as that of the power supply.
6.1 Installation site
When selecting the location, follow the instructions below:
• The wine refrigerator should stand in the coldest part of the room, away from heat sources (ovens, heating devices or
radiators).
• The location must not be damp or wet.
• The wine refrigerator must not be exposed to direct sunlight. This can damage the acrylic coating and lead to higher power
consumption.
• The ground must be level and sufficiently stable to bear the wine refrigerator at full capacity.
• The wine refrigerator must be sufficiently ventilated. The ventilation slots on the front of the wine refrigerator must not be
obstructed.
• Observe the installation dimensions, see technical data.
6.2 Ventilation
NOTICE!
• Ensure that the ventilation slots remain clear.
Obstructed ventilation slots lead to increased power consumption and can damage the wine refrigerator.
• Model E7FG needs at least 30 mm space on the rear side for ventilation (fig.
6.3 Adjusting the feet
► Make sure the wine refrigerator is level by adjusting the feet (fig.
6.4 Reversing the door
You can change the hinge of the door, so that it opens to the left rather than the right.
For reversing the door follow the steps in the mentioned figures:
► E18FGB and E49FGB (fig.
► B29G and B68G (fig.
► E7FG, E16FG, E28FG, E45FG, C20G and C50G (fig.
► B162S, B195S, C101G, C125G, E91FG, E115FG (fig.
6.5 Mounting the door handle
Mount the door handle on the side opposite to the hinge. To get access to the bores partly lift off the sealing at the inside of the
door (fig. , on page 5).
6.6 Adjusting the ventilation grille
► Adjust the height of the ventilation grill (fig.
6.7 Electrical connection
NOTICE!
Leave the wine refrigerator to stand upright for about 2 hours after transporting, before you connect it to the
power supply. Otherwise this could cause faults in the cooling system.
Observe the following when connecting the wine refrigerator:
• Connect the wine refrigerator to a circuit that is protected with 15 A.
• Check that the voltage specification on the type plate is the same as that of the power supply.
• Have the socket and power circuit checked by a qualified electrician to ensure that the socket is earthed correctly. Do not
use an extension cable or a multiple power socket.
• The cable must rest securely behind the wine refrigerator and not be allowed to lie or hang unprotected.
• Ensure that the power cable is not jammed when pushing the wine refrigerator into place.
EN
, on page 7 to fig. , on page 8)
, on page 8 to fig. , on page 8)
, on page 6).
, on page 5).
, on page 9 to fig. , on page 9)
, on page 10 to fig. , on page 11)
4445103123
Mounting and connecting
, on page 5).
17