Metal Works ODC65 Mode D'emploi page 9

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

ODC65 - NLFRENES - v1.0 - 20082013
EN
Operation instructions
1 Oil suction
a. We have attached 2 pieces φ 6 suction tips and 1 piece φ 8 suction tip, you can choose to use which
model according to your requirement.
b. Please smear some lubricant around the rubber ring of the suction plug.
c. Push the suction plug to the quick coupler of the suction tips.
d. Turn off the valve under the measuring cup, turn on the air intake valve on the top of measuring cup,
connect the quick coupler on top of the measuring cup with the air intake pipe, turn on the air intake
valve and adjust the air intake pressure (3 - 5 bar), the vacuum gauge pointer move and the degree of
vacuum can be adjusted according to operator's requirement, the Max. degree of vacuum is not less than
0.57 bar. You can fill the air while oil suction, also you can cut down the air resource and remove to do
oil suction. You only to turn on the valve of the oil suction pipe when for oil suction, the oil can be suction
from the oil tank to the measuring cup, take note the oil level, the oil can not exceed the STOP position.
e. Oil flows from the measuring cup to the oil tank.
Turn on the valve under the measuring cup, the oil will flow from the measuring cup to the oil tank;
f.
Turn on the valve under the measuring cup, connect the oil suction plug with oil suction tips, insert the
suction tip to the tank where need suction, turn on the top valve and adjust the air intake pressure, when
the vacuum gauge pointer reaches your requirements, so you can do oil suction while filling the air, also
you can turn off the air intake valve first and move the machine to make oil suction, you can see the oil
level by the outside transparent oil lever.
2 Discharging oil
a. Please take note that you must turn off the valve under the measuring cup before discharging oil , unless
will damage the transparent measuring cup.
b. Turn on the control valve of oil discharging opening under the tank, put the steel elbow of the oil pipe on
the opening of the oil storage tank.
c. Turn off the valve under the oil tray.
d. Connect the air intake pipe(required fitting pressure regulator) with the quick coupler on the top of tank,
turn on the air intake valve, adjust the air intake pressure to 0.5 bar, then fill the air and the oil will be
discharged out to the oil storage tank.
3 Oil collection
Turn off the valve under the measuring cup, turn on the valve under the oil tray and the air intake valve on
the top of tank, adjust the oil tray to suitable height, move the machine to the position which under the oil
discharging machine, let the oil tray and the oil discharging opening in the same vertical position.
®
9

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

724561003

Table des Matières