Maintenance And Storage - CERTIFIED 060-0582-0 Guide D'utilisation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

12
model no. 060-0582-0
9. Never direct the discharge toward people
or areas where property damage can occur.
Keep children, pets and other bystanders
away from the work area.
10. Do not overload the machine capacity by
attempting to clear snow at too fast a rate.
11. Look behind and use care when backing up
with the electric snowblower.
12. Make sure the 2 W LED light is operational
when using the electric snowblower at
night or under conditions of poor visibility.
Always check your footing during operation
and keep a firm hold on the handles. Walk,
never run, with the unit.
CLEARING A CLOGGED DISCHARGE
CHUTE
Hand contact with the rotating paddle inside
the rotor housing is the most common cause
of injury associated with electric snowblower.
Never use your hands to clear a clogged rotor
housing.
To clear the rotor housing:
Shut the motor off and disconnect the unit
from the power supply.
Wait 10 seconds to be sure the rotating
paddle have come to a complete stop.
Always use a clean-out tool, not your
hands, to free the rotating paddle.

MAINTENANCE AND STORAGE

Check all fasteners at frequent intervals
for proper tightness to ensure that the
equipment is in safe working condition.
Always refer to the operator's manual for
important details, such as how to properly
store your electric snowblower for an
extended period of time.
Maintain or replace safety and instruction
labels as needed.
I contact us: 1-844-428-7277
Electrical Safety
Electric shock may cause SEVERE INJURY or
DEATH. Heed these warnings:
Run the machine a few minutes after
throwing snow to prevent the rotor blades
from freezing.
DOUBLE-INSULATED: GROUNDING
NOT REQUIRED. WHEN SERVICING,
USE ONLY IDENTICAL REPLACEMENT
PARTS.
This electric snowblower is double-
insulated, eliminating the need for a
separate grounding system. Use only
identical replacement parts. Read the
instructions before servicing double-
insulated appliances. Use this snowblower
only as described in this manual.
Ground fault circuit interrupter (GFCI)
protection should be provided on the
circuit(s) or outlet(s) to be used for this
electric snowblower. Receptacles are
available having built-in GFCI protection
and may be used for this measure of
safety.
To prevent electric shock, use only with an
extension cord suitable for outdoor use.
Before use, check that the extension cord is
in good condition. When using an extension
cord, make sure to use one heavy enough
to carry the current your product will draw.
For lengths less than 50 ft (15 m), a No.16
AWG (or greater) extension cord should be
used. An undersized cord will cause a drop
in line voltage resulting in loss of power
and overheating.
Do not allow any part of the electric
snowblower to make contact with water
while it is in operation. If the product

Publicité

Chapitres

Table des Matières
loading

Table des Matières