10
model no. 060-0582-0
area to be plowed before each use. Remove
all objects, such as rocks, broken glass,
nails, wire, or string, which can be thrown
by or become entangled in the snowblower.
Keep the area of operation clear of all
spectators, particularly children and pets.
4.
Excessive force – The snowblower was
designed to respond at a certain rate
for various snow conditions for optimum
safety and performance. Do not force it;
keep pressure constant.
5.
Malfunctioning switch – Do not use the
snowblower if the switch does not turn it
on and off. Any electrical appliance that
cannot be controlled by the switch is not
safe to use and must be repaired.
6.
Hitting an object – If the snowblower
accidentally strikes an object, follow these
steps:
i)
Stop the snowblower and unplug the
unit
ii) Inspect for damage
iii) Repair or replace any damaged part
before restarting and operating the
snowblower.
7.
Discharge chute safety – Never direct the
snow discharge chute at the operator, at
bystanders, at vehicles, or at windows.
The discharged snow stream and foreign
objects accidentally picked up by the
snowblower can cause serious damage and
personal injury. Do not use your hands to
unclog the discharge chute. Stop the motor
before removing debris.
8. Hand-held operating position – Operation of
the snowblower in the hand-held position
is unsafe.
9. Abnormal operation – If you notice the
snowblower running in an unstable state
or hear abnormal sounds from the engine,
immediately stop the machine, disconnect
the power,
10. Noise control – When using the snowblower,
you must respect local laws and regulations
I contact us: 1-844-428-7277
11. When work is completed – Disconnect the
12. Store safely – Store the snowblower
13. Maintain for safety and longevity – Check
Always check that all bolts, nuts, and knobs are
tight before using the snowblower!
This electric snowblower meets or exceeds
the B71.3 specifications of the American
National Standards Institute in effect at the
time of production.
Read and understand the contents of this
manual before you start the motor.
regarding noise control and environmental
protection. To avoid noise disturbance,
you should carefully decide upon an
appropriate operation time and consider
the surrounding conditions.
snowblower from the power source when
not in use, when changing accessories,
and before performing any maintenance
function.
indoors in a dry area between uses. Keep
it in a locked area, where children and
unauthorized users cannot gain access.
Do not store the machine while it is still
connected to the power source as this may
result in damage and injury.
for misalignment or binding of moving
parts, breakage of parts, and any other
conditions that may affect the unit's
operation. If damaged, repair or replace the
damaged part before use. Use only original
replacement parts designed specifically for
your model. When replacing any parts,you
must strictly observe the instructions
and procedures described in this manual.
Special care should be made to any rubber
parts, since these parts may increase the
engine load and decrease its mechanical
power if damaged.
It is used to alert you to potential
personal injury hazards. Obey all