Unloading Fasteners; Clearing Jams - Power Fist 8558421 Manuel D'utilisation

V 4.0
LOADING FASTENERS
1. Connect the tool to the air source.
2. Pull pusher(A) back until the fasteners
follower falls behind the fasteners.
Insert strip of fasteners into the notch
upon the magazine(B). Be sure the
fasteners are pointed downward.
3. Press the latch, then pull pusher to let
it go back to move the fasteners up to
the driving mechanism. The pusher
will stop when it rests against the end
of the fastener.
WARNING: The tool may fire when it first connected to the air source. Always connect the
tool to the air source before loading fasteners to prevent injury from unintended cycling.
Always make sure the tool's magazine is empty at the beginning of each work session,
before connecting to an air source.
WARNING: Use only those fasteners recommended for use with this tool. Fasteners not
identified for use with this tool by the tool manufacturer are able to result in a risk of injury
to persons or tool damage when used in this tool.
WARNING: Keep the tool pointed away from yourself and others when loading fasteners.
Failure to do so could result in possible serious personal injury.
WARNING: Never load fasteners with the workpiece contact or trigger activated. Doing so
could result in possible serious personal injury.

UNLOADING FASTENERS

Unloading is the reverse of loading. Always disconnect the air resource before unloading.
WARNING: Always unload all fasteners before removing tool from service.
WARNING: Always disconnect the air resource before unloading.

CLEARING JAMS

Occasionally, a fastener may become jammed in
the firing mechanism of the tool, making the tool
inoperable. To remove a jammed fastener, follow the
steps below:
1. Disconnect the tool from air source.
2. Remove fasteners from the tool. Failure to
do so will cause the fasteners to eject from the front of the tool.
3. Pull the jammed fastener out from the nose, use pliers or a screwdriver if required to
clear the jammed fastener. Using caution not to bend or damage the driver blade.
4. Reconnect the tool to the air source.
5. Reload the tool with fasteners.
WARNING: Make sure there is no fastener in magazine before clearing a jam.
8
34° 3-1/2 in. Clipped Head Framing Nailer
Notch upon the magazine(B)
Pusher(A)
For technical questions call 1-800-665-8685
8558421
Latch