Anti-Dust Cap; Lubrication - Power Fist 8558421 Manuel D'utilisation

V 4.0
5. Push the trigger pin(D) back, using a little hammer if necessary. Use Caution not to
damage the tool when reinserting the trigger pin.
6. Put the o-ring back to fasten the trigger pin(D).
7. Grip the tool firmly to maintain control. Position the nose of the tool onto the
work surface.
8. Push the tool against the work surface to depress the workpiece contact.
9. Squeeze the trigger to drive a fastener.
CONTACT ACTUATION MODE
Contact actuation allows very fast repetitive
fastener placement.
1. Disconnect the tool from the air source.
2. Remove the o-ring from the
trigger pin(D).
3. Pull the trigger pin(D) out.
4. Put the blue trigger on.
5. Push the trigger pin(D) back, using a little hammer if necessary.
6. Put the o-ring back to fasten the trigger pin(D).
7. Grip the tool firmly to maintain control. Position the nose of the tool onto the
work surface.
8. Squeeze and hold the trigger, push the tool against the work surface to depress the
workpiece contact and drive a fastener.
NOTE: In the contact actuation mode, the tool may also be operated by depressing the
workpiece contact against the surface and squeezing the trigger.
WARNING: During normal use the tool will recoil immediately after driving a fastener. This
is a normal function of the tool. Do not attempt to prevent the recoil by holding the tool
against the work. Restriction to the recoil can result in a second fastener being driven from
the tool. Grip the handle firm ly and let the tool do the work. Failure to heed this warning can
result in serious personal injury.
MAINTENANCE
WARNING: Any time inspection, maintenance, and cleaning are done:
•
Disconnect the tool from the air resource.
• Empty the magazine completely.

ANTI-DUST CAP

Each tool is packed with an anti-dust cap on the air connector.
Keep the anti-dust cap cover the air connector when the tool is not in use.

LUBRICATION

Frequent, but not excessive, lubrication is required for best performance after long periods of
use. Oil for pneumatic fastening tools is added through the air line connection and will lubricate
internal parts. Do not use detergent oil or additives. These lubricants will cause accelerated
wear to the seals and bumpers in the tool, resulting in poor tool performance and frequent
tool maintenance.
CAUTION: Lubricate tool only with specified lubricants.
10
34° 3-1/2 in. Clipped Head Framing Nailer
For technical questions call 1-800-665-8685
8558421
Trigger pin(D)