For Your Safety - Bosch GKS 55 Instructions D'utilisation

EURO • Printed in Germany • BA 1 609 929 535 • GKS 55/65/66 CE • GB • OSW 11/99
GKS 55/65/66 CE - Buch Seite 13 Dienstag, 9. November 1999 3:57 15

For Your Safety

Working safely with this machine
is possible only when the operat-
ing and safety information are
read completely and the instruc-
tions contained
strictly followed. In addition, the
general safety instructions in the
enclosed booklet must be fol-
lowed. Before using for the first
time, ask for a practical demon-
stration.
If the cable is damaged or cut
through while working, do not touch
the cable but immediately pull the
mains plug. Never use the machine
with a damaged cable.
Wear protective glasses, hearing
protection and a dust protection
mask.
Wear protective gloves and sturdy
shoes.
When necessary, also wear an
apron.
For long hair, wear hair protection. Work only
with close-fitting clothes.
The machine must be operated only with the
associated protective devices.
Always use the riving knife 21.
The swinging protection guard 13 must be free
to move; it must not become jammed in the
open position.
For stationary use, the machine may be oper-
ated only on a sawing table with restarting pro-
tection.
Always direct the cable to the rear away from
the machine.
Connect machines that are used in the open
via a fault current (FI) circuit breaker with a trig-
gering current of 30 mA maximum. Use only
extension cables that are intended for outdoor
use.
Insert the mains plug only when the machine is
switched off.
Clamp the workpiece in case it does not remain
stationary from its own weight.
Do not leave the tool key inserted.
When working with the machine, always hold it
firmly with both hands and provide for a secure
stance.
Apply the machine to the workpiece only when
switched on.
When working, always guide the machine
away from the body.
therein are
The cutting path must be free of obstacles both
above and blow.
The saw blade should not protrude more
than 3 mm out of the work piece.
Keep hands clear of the rotating saw blade. Do
not come into contact with the rotating saw
blade on the underside of the workpiece.
Do not stick fingers into the sawdust ejector 16.
Do not work overhead with the machine.
Do not saw into nails, screws, etc.
The dust that is produced while working is det-
rimental to health. Use dust extraction and
wear a dust mask.
Do not work with materials containing asbes-
tos.
Protect saw blades against shocks and im-
pacts.
Do not tilt the saw blade.
If the saw blade jams, switch off the machine
immediately.
The spindle locking button 1 may be actuated
only when the saw blade is at a standstill.
After switching off, do not brake the saw blade
to a stop by applying side pressure.
Always switch off the machine and allow to
come to a stop before putting down.
Use only sharp, flawless saw blades. Replace
immediately cracked, bent or dull saw blades.
Saw blades of highly alloyed, high speed steel
must not be used.
The saw blade and riving knife must not be-
come stuck in the cut. The saw tooth offset
must be wider and the main body of the saw
blade thinner than the thickness of the riving
knife.
Before each use of the machine, check the ca-
ble and plug. If damage is detected, do not use
the machine. Have repairs performed only by a
qualified technician. Never open the machine
yourself.
Bosch can assure flawless functioning of the
machine only when original accessories are
used.
13