Important - Madas EV-1 Manuel

5.1 - CONNECTOR/ELECTRONIC BOARD REPLACEMENT
fig. 1
28 27
1
2 33
g. Loosen the 4 fastening screws (1) of the cover (2);
h. Remove the over (2) and loosen the cable gland (3) with a 22mm commercial spanner;
i. Loosen the screws of the main terminal board (31) and remove the existing electric wiring by extracting the cables from
the terminal board and cable gland (3);
j. Using an 8 mm socket spanner, loosen the fastening nut (28) and remove it together with the toothed washer (27);
k. Remove the connector/board (30) as shown in
two wires that come out;
l. Wire the two wires coming out from the rear terminal board (32) of the new connector/board.
IMPORTANT: Being careful not to pinch the two cables, in the centre pin (29) insert: the new connector/board + toothed
washer (27) + nut (28). With an 8mm socket spanner, tighten the nut (28);
Proceed as specified in points c-f in section 3.2.
g
j
Madas Technical Manual - 1|1.5c - REV. 0 of 10
30
31 29 3
. Loosen the screws from the rear terminal board (32) and remove the
k
h
k
May 2018
th
19
i
l
19
4
EV(F)-1-3-6
32
30