What To Do If - IKEA ANRATTA Mode D'emploi

ENGLISH
WARNING!: Do not remove
any cover. The door seals and the
door seals areas must be regularly
inspected for damage. If these
areas are damaged the appliance
should not be operated until it

What to do if ...

Problem
The appliance does not
work.
The display shows the
letter "F" followed by a
letter or number
The food is unevenly
heated.
Food isn't turning.
Authorized Service Centre
Before calling the Authorized Service Centre:
1. See if you can solve the problem on your
own (see the "What to do if ..." table).
2. Switch the appliance off and on again to see
if the problem has disappeared.
If the fault persists after the above checks,
contact IKEA Authorized Service Centre.
Always specify:
- the type of fault;
- exact type and model of appliance;
- the Authorized Service Centre number (the
number given after the word "Service" on the
Possible cause
The mains power supply or the
appliance is not connected.
The door isn't closed.
Software fault.
Very thin parts such as chicken
wingtips and such are not
shielded.
The food was heated at a
power level too high.
The turntable has stopped.
The turntable has stopped.
have been repaired by a qualified
technician.before performing any
maintenance operation - risk of
electrical shock. Never use steam
cleaning equipment.
Solution
Check your fuses and ensure that there is
power avaliable.
Open and then close the door before you
try again.
Contact you nearest After-sales Service
Centre and state the letter or number that
follows the letter "F".
Shield the thinner parts with aluminum foil.
Choose a lower power level.
Check that the turntable and turntable
support is in place and the food is well
centered, not touching the cavity walls.
Check that the turntable and turntable
support is in place and the cavity bottom
is clean.
rating plate) located on the inside edge of the
oven cavity (visible when the door is open);
- your full address;
- your telephone number.
- If any repairs are required, please contact
IKEA Authorized Service Centre(to guarantee
that original spare parts will be used and
repairs carried out correctly).
16