Basic safety instructions
·
This electrical appliance is exclusively determined for private use
and using in:
- staff kitchen areas in shops, offices and other working
environments
- in farm houses
EN
- by clients in hotels, motels and other residential type environments
- on bed and breakfast type environments.
·
Have repairs of Cloer electronic appliances carried out only by
authorized Cloer specialist dealers or by the Cloer customer service.
Improper repairs can involve substantial dangers for the user.
Furthermore, this will void your warranty claims.
·
Only operate the appliance at household-usual power sockets. Check
if the mains voltage stated on the type plate is up to that of your
power supply network.
·
If the connector is damaged, it must be replaced by an authorized
Cloer specialist dealer or the Cloer customer service to avoid
endangering.
·
Pull power plug of the power socket
- in case of a defect.
- if the appliance is not used for a longer time.
- before any cleaning.
·
Only pull at the plug, never at the feed cable.
·
Do not tighten the feed cable too tight as otherwise the appliance is
likely to tip over.
·
Do not stretch the feed cable over sharp edges.
·
Do not use the feed cable for carrying and protect it from heat
(hotplate / open flame).
·
This appliance can be used by children aged from 8 years and above
if they have been given supervision or instruction concerning use of
the appliance in a safe way and understand the hazards involved.
·
Cleaning and user maintenance shall not be made by children unless
they are older than 8 and supervised.
·
Keep the appliance and its cord out of reach of children less than 8
years.
·
Children shall not play with the appliance.
·
This appliance is not intended for use by persons with reduced
physical, sensory or mental capabilities, or lack of experience and
knowledge, unless they have been given supervision or instruction
concerning use of the appliance by a person responsible of their
safety.
·
Protect your appliance from humidity (splash water / rain).
·
Let the appliance cool off before cleaning or stowing away.
·
This appliance should not be operated due to an external timer or
separate remote control system.
·
Do not immerse appliance in water and do not clean under running
water!
·
Warning: Lignite or similar fuels must not be used in this device.
·
The device should be operated via a residual current device (RCD)
with a trigger current not exceeding 30 mA.
·
The device must be connected to a power outlet with protective
ground.
·
The mains connection line should be regularly inspected for signs
of damage. The device must not be used if the connection line is
8
damaged.