Technical Specifications; Lubrication - GYS TROLLEY IW1 Mode D'emploi

- Check parts for cracks or points of wear and tear.
- Check the tightness of bolts and screws. See section 'ASSEMBLY PROCEDURE' for instructions on how to tighten
torques.
- Check the condition of the arm's articulated parts. Add a suitable grease (neutral grease) to moving parts (arm joints).
- Check that the castor wheels are working properly. Grease the bearings. Check that the rubber surfaces are in good
condition.
- Check the condition of the filter (remove dust if necessary). Bleed the filter.
- Check that the air regulator is working properly.
- Check the oil level in the lubricator.
After assembly/disassembly, the impact-wrench attachments fitted to the plate must be checked, as well as the
tapped plate attachments for the stop screws. Available in the sections entitled 'Assembling the impact-wrench' and
'Assembling the column'.
MAINTENANCE
Dusting can be done with an compressed-air blower before cleaning.
Wash the impact-wrench support trolley with a product suitable for painted steel surfaces. Follow the product's cleaning
instructions. Dry the wrench-holder support with a cloth after cleaning. Never use a high-pressure sprayer as this can
damage the paintwork.
TROUBLESHOOTING
The impact-wrench support trolley is designed for effective and safe use provided that the maintenance instructions
have been followed. However, if you do encounter any operating problems, here is some advice. If problems persist,
contact the repairer or the manufacturer.
If the arm doesn't move or has difficulty moving:
- Check that all parts of the arm are present, check the 'ASSEMBLY PROCEDURE' section.
- Check that the fixing screws are tightened to the correct torque and that the moving parts (arm joints) are properly
lubricated, see section entitled ' MAINTENANCE'.
If the impact-wrench support trolley makes a strange noise:
- Check that the impact-wrench support trolley's component parts are correctly mounted, see 'ASSEMBLY PROCEDURE'
section.
- See section entitled 'MAINTENANCE'.

TECHNICAL SPECIFICATIONS

Balancing capacity (impact wrench attachments)
Product's height
Product's width
Product's depth
Connection to the air network
Minimum airflow rate
Débit d'air minimum

Lubrication

Impact-wrench holding connector and handle
Adjusting the balance
Storage temperature
Operating temperature
28
TROLLEY IW1
70 Kg
From 1 to 20 kg
95 cm
85 cm
86 cm
½'' (1.27 cm) 10 bar max. (built-in regulator)
Recommended pressure, 6 to 6.5 bar
Can be connected in ¼'' (6 mm) 10 bar max.
(will lower the impact wrench's performance)
Depending on the impact wrench
Recommended oil: ISO 22 (ISO 32 will work)
Adjust according to the manufacturer's recommendations
Berne key (from 36 mm to 44 mm)
Ratchet spanner with spark plug socket (21 mm)
(not supplied)
0°C à 60°C
5°C à 50°C
EN