GYS TROLLEY IW1 Mode D'emploi page 27

BRAKE
The impact-wrench support trolley is equipped with a synchronised hand brake that acts on each of the two rear wheels.
It is operated by pulling up the handle on the left when sitting on the seat. It is deactivated by lowering this handle.
AIR TREATMENT
The impact-wrench support trolley comes with a filter, regulator and lubricator unit (FRL).
It is recommended to connect it to a specific air network with half-inch (1.27 cm) connections enabling an increased
air flow.
The recommended operating air pressure is 6 to 6.5 bar (0.6 to 0.65 MPa).
The maximum pressure is 10 bars.
It is possible to add a quarter-inch (6 mm) quick connector between the filter regulator and the lubricator to connect a
pump or any other pneumatic accessory.
A silencer and/or coalescing filter can be fitted to the machine to separate any oil from the impact wench's returning
airflow; this recycles the used oil and avoids oil mist in the return airflow or the impact wrench's air outlet.
SAFETY DURING USE AND TRAVEL
Be aware the risk of electric shocks when bringing the impact wrench back towards yourself. Set a balancing force
that is just sufficient.
Always lock the arm in place with the pins when moving the device. Do not sit on the impact-wrench support
trolley to avoid opening the arm and increasing the risk of electric shocks.
Take particular care when passing through doorways, over electrical wires or other objects on the ground.
Handles must be gripped in a way that prevents you from hitting your hands on objects protruding from the wall,
shelves or other objects.
INSERTING AND CHANGING THE IMPACT-WRENCH SUPPORT
The user is responsible for the correct installation or replacement of the impact-wrench support. As described in
the section 'Assembling the impact-wrench'.
Always use a chock behind the rear wheels when installing/changing the impact-wrench support.
Always secure the arm with locking pins when fitting/changing the impact-wrench support.
Always set the balancing force to the minimum when fitting/changing the impact-wrench support.
The impact-wrench support must always be securely fastened to the impact-wrench plate to prevent the impact
wrench from falling.
It is recommended that two people carry out this operation.
The impact-wrench support's maximum load must not exceed 20 kg.
MAINTENANCE
In order for the impact-wrench support trolley to work at its best, it is important to carry out regular maintenance
following the instructions below. The maintenance interval is defined according to normal use with a daily use of eight
hours. For more intensive use, the maintenance should be carried out more frequently.
TROLLEY IW1
EN
27