Berner BAG-115-2 Notice Originale page 15

OBJ_BUCH-2574-001.book Page 15 Monday, July 27, 2015 8:31 AM
 Secure the workpiece. A workpiece clamped
with clamping devices or in a vice is held more
secure than by hand.
 After breakage of the grinding disc during oper-
ation or damage to the holding fixtures on the
protection guard/power tool, the machine must
promptly be sent to an after-sales service agent
for maintenance.
 Adjust protection guard in such a manner that
sparking toward the operator is prevented.
 Do not touch grinding and cutting discs before
they have cooled down. The discs can become
very hot while working.
 Actuate the spindle lock button only when the
grinder spindle is at a standstill. Otherwise, the
machine may become damaged.
 After mounting the grinding tool and before
switching on, check that the grinding tool is
correctly mounted and that it can turn freely.
Make sure that the grinding tool does not
graze against the protection guard or other
parts.
 When operating the machine with power from
mobile generators, loss of performance or un-
typical behavior can occur upon switching on.
 By applying too high application force, the ma-
chine can be subject to overload. Overload
can lead to overheating and damage of the
power tool. After heavily straining the power
tool, continue to run it at no-load for several
minutes in order to cool it down.
 Do not use the power tool with a cut-off stand.
 Never use a cutting disc for roughing.
 The quick-clamping nut may be used only for
grinding or cutting discs. Use only a flawless,
undamaged quick-clamping nut.
 For operations with the rubber sanding plate
or with the cup brush/wheel brush/flap disc,
always mount the hand guard .
 For cutting with bonded abrasives, always use
a protection guard for cutting.
 Provide for sufficient dust extraction when
cutting stone.
 Wear a dust respirator.
 To save energy, only switch the power tool on
when using it.
1 619 P12 663 • 27.7.15
 Products sold in GB only: Your product is fitted
with a BS 1363/A approved electric plug with in-
ternal fuse (ASTA approved to BS 1362).
If the plug is not suitable for your socket outlets,
it should be cut off and an appropriate plug fitted
in its place by an authorised customer service
agent. The replacement plug should have the
same fuse rating as the original plug.
The severed plug must be disposed of to avoid a
possible shock hazard and should never be in-
serted into a mains socket elsewhere.
Products sold in AUS and NZ only: Use a resid-
ual current device (RCD) with a rated residual
current of 30 mA or less.
Symbols
The following symbols are important for reading
and understanding the operating instructions.
Please take note of the symbols and their meaning.
The correct interpretation of the symbols will help
you to use the machine in a better and safer man-
ner.
Symbol Meaning
Article number
Read all safety warnings and all
instructions
Before any work on the machine
itself, pull the mains plug from the
socket outlet
Wear protective gloves
Always wear ear protection.
Wear safety glasses/goggles
Movement direction
English | 15