Orbegozo CP 80142 Manuel D'instructions page 13

CP 80142
HOW TO REPLACE A LIGHT BULB
1. Switch the device off (preferably, turn it off at the circuit breaker) and leave to cool. (Take care: light
bulbs can get very hot when in use.)
2. Remove the bulb by holding it firmly and turning it anti‐clockwise.
3. Take a new bulb and put it carefully into its holder. Screw it in clockwise.
4. Put the power supply on again and switch on.
Important: The bulbs for this fan must be E 27 / 60W (x2).
CLEANING
Clean with a soft, dry cloth. Never use scouring pads, abrasive or chemical cleaners. Do not
allow condensation to come in contact with the electrical components.
MODEL
CP 80142
Disposal of old electrical appliances.
The European directive 2002/96/EC on Waste Electrical and Electronic Equipment (WEEE), requires that
old household electrical appliances must not be disposed of in the normal unsorted municipal waste
stream. Old appliances must be collected separately in order to optimize the recovery and recycling of
the materials they contain, and reduce the impact on human health and the environment. The crossed
out "wheeled bin" symbol on the product reminds you of your obligation, that when you dispose of the
appliance, it must be separately collected. Consumers should contact their local authority or retailer for information
concerning the correct disposal of their old appliance.
DECLARATION OF CONFORMITY:
This device complies with the requirements of the Low Voltage Directive 2006/95/EC and the requirements of
the EMC directive 2004/108/EC.
FAN POWER BULB POWER
70 W 60 W (X2)
VOLTAGE FREQUENCY
220 – 240 V 50 HZ
13