Maintenance Summary Table; Implements - Grillo G52 Emploi Et Entretien

Masquer les pouces Voir aussi pour G52:

Emploi et entretien (40 pages)

Table Des Matières

Table des Matières

Les langues disponibles

PROCEDURE

check the level

Engine oil

Air filter

check/adjust

Spark plug

Check the level

Gearbox oil

Check that the engine intake grid is

clean

Check blade

Cutter bar

attachment

Check that tines are well-sharpened

and well-fixed

Lubricate with grease

Check wheel axle clearance (free

play)

● recommended procedure

‫ ٭‬procedure to be carried out if necessary

ROTARY TILLER

The rotary tiller is used to break the surface layer of the ground in order to increase its permeability

and at the same time to get rid of weeds (fig. 10). Till in 1st speed if the soil is hard and tough or in

2nd speed in soft, sandy soil. The working depth can be adjusted by lifting or lowering the central

knife located under the rotary unit. It is recommendable to start tilling with the knife in the lowest

position, and then to raise it if greater depth is required. Important: two safety screws are mounted

on the tiller fixing the hoes supports and used to protect the transmission of the machine in case a

stone or a foreign object abruptly blocks the rotation of the tiller. Should this be the case,

immediately switch the engine off and replace the screws fixing the hoes supports (fig. 11). Use

stainless steel screws 12.9 (Grillo spare part no. 146374).

Note that on hard soils the machine may jump forward. In this case set the central knife in the

lowest position (fig. 12, n. 2). Check that the hoes are mounted correctly (fig. 12). To set the rotary

tiller at 33 cm the kit no. 929512 is needed.

CAUTION: Keep your hands and feet away from the rotary tiller hood when the engine is

running, rotation of the tiller is highly dangerous. Before performing any kind of operation

on the tiller (e.g. replacing hoes), ALWAYS SWITCH OFF THE ENGINE.

Translation of the Original Instructions