Rinse Aid Dispenser Adjustment(For Dishwashers With Hydraulic Dispenser, Only); Detergent (Dishwasher Without Detergent Dispenser) - Bartscher 109.142 Mode D'emploi

GB
USE AND MAINTENANCE MANUAL
Pag. 6
Set washing tank temperature:
Press A push-button several times until wording " t " "55" is displayed;
then adjust it by means of G and L push-buttons.
Once the temperatures have been set, just hold push-button A pressed
to return to the previous condition.
2.6 RINSE AID DISPENSER ADJUSTMENT
(for dishwashers with hydraulic dispenser, only)
A
Before adjusting, the dispenser and hose need to be filled
using the primer button (A).
To adjust use the ring nut (B) situated at the center of the
dispenser, rotating clockwise reduces the quantity,
counterclockwise increases it.
The dispenser must not operate empty
An excessive amount of rinse agent causes bluish stripes on the
dishes and creates foam in the wash tank.
B
If the glassware is covered with droplets of water and it dreis rather
slowly this means that the amount of rinse agent is insufficient.
7 cm. of tubing = 1 gram of product
2.7 DETERGENT
(Dishwasher without detergent dispenser)
Put the amount of detergent recommended by the
manufacturer into the tank. Depending on the type of
detergent this may vary from 2 to 4 gr/lt of water in the tank.
Detergent needs to be added approximately every 5 washes
as per the manufacturer's instructions.