ADJUSTING THE LEVEL
Make sure the refrigerator is level so that you can
make final adjustments. Use a level to test if the
refrigerator is level both side to side and back to
front. If the refrigerator is not level, it will not be
possible to get the doors perfectly even, which
may cause moisture condensation and increased
energy bills. Below is an example of how to level
the refrigerator if the left side of the refrigerator is
lower than the right side.
How to adjust the level
1. Open the freezer drawer and remove the lower
basket.
2. Insert a flat-blade screwdriver (-) into the
notch on the left control lever, and then turn
it counter-clockwise to level the refrigerator.
(You turn the lever clockwise to lower the
refrigerator and counterclockwise to raise it.)
flat-blade
screwdriver (-)
Both control levers must be touching the
floor to avoid possible personal injury or
CAUTION
property damage because of tipping.
• If the right side is lower, perform the
same procedure, but with the right
control lever.
• It is difficult to remove the cover leg
front from the refrigerator, so we do not
recommend making small adjustments
with the control lever. Instead, refer to
the next page for the best way to make
minor adjustments to the doors.
DA68-02657A-12.indb 15
Control Lever
MAKING MINOR ADJUSTMENTS
BETWEEN DOORS
Remember, a leveled refrigerator is necessary
for getting the doors perfectly even. If you need
help, review the previous section on leveling the
refrigerator.
Fixed part
• The left door is fixed. To make minor
adjustments between doors, adjust only
the right door.
1. Pull out the freezer drawer ( 1 ), then you can
see the lower hinge ( 2 ).
2. Insert a philips screwdriver (+) ( 3 ) into the
shaft ( 4 ) of the lower hinge.
3. Adjust the height by turning a philips
screwdriver (+) ( 3 ) clockwise (
UP
counterclockwise (
2
4
1
3
• When you turn a philips screwdriver (+)
counterclockwise (
move up.
Adjustment
part
) or
DOWN
).
3
), the door will
UP
setting up _15
2018. 10. 8. 오후 5:46