Installation And Placement - Denios PolySafe-Depot Typ K Mode D'emploi

vehicles using appropriate means (eg impact protection barriers). When located outdoors, the Depot must
have sufficient protection from wind, rain and snow etc. and direct sunshine (eg with a shelter).
3.3

Installation and placement

Remove the packing foil.

Ensure the PolySafe Depot K is installed

level at the final placement location (base
plates are available). The double wing
doors must be parallel to the body.
When correctly installed, the double wing doors
should be able to be easily closed and locked.
Mounting kit (optional)
Mark the mounting points.

Drill the holes (ø12mm, 140mm deep) for

the ground anchors supplied.
Fit the ground anchors in the holes.

Install the PolySafe Depot (using the

base plates if necessary).
Secure the Depot to the floor and secure

the mounting brackets (4x) to the internal
thread on the edge of the spill pallet.
Tighten the nuts to a torque of T

Nm.
Fitting and removing the shelving rack.
235412_BA_PSD_K_002_INT
= 45
inst
Seite 13 von 31
07/2015