Description
1 Foil & Cutter cassette
2 Long hair trimmer
3 Precision setting switch
4 On/off switch
5 Charging lights (green)
6 Low-charge light (red)
7 Replacement light for shaving parts
8 Shaver power socket
9 Special cord set
10 Charging stand (380s only)
11 Etui (380s only)
12 Protection cap (340s only)
Charging
Recommended ambient temperature for charging is 5 °C to 35 °C.
The battery may not charge properly or at all under extreme low or high
temperatures. Recommended ambient temperature for shaving is 15 °C
to 35 °C.
Do not expose the shaver to temperatures higher than 50 °C for extended
periods of time.
• Using the special cord set (9), connect the shaver or the charging stand (10)
to an electrical outlet with the motor switched off.
• When charging for the first time or when the shaver is not used for a few
months, leave the shaver to charge continuously for 4 hours.
• Once the shaver is completely charged, discharge the shaver through
normal use. Then recharge to full capacity. Subsequent charges will take
about 1 hour.
• A full charge provides up to 45 minutes of cordless shaving time depend-
ing on your beard growth. However, the maximum battery capacity will
only be reached after several charging/discharging cycles.
• 5-minute quick charge is sufficient for a shave.
Charging lights (5)
The green charging lights show the charge status of the batteries
(345s/340s: 1 charging light). The green charging light blinks when the
shaver is being charged or switched on.
When the battery is fully charged, all green charging lights (345s/340s:
1 charging light) shine permanently, provided the shaver is connected to an
electrical outlet.
(380s only)
7