Pattfield Ergo Tools PE-ART 18 Li BASIC Traduction De La Notice Originale page 263

5.4 Adjusting the additional handle (Fig. 8)
Undo the adjustment lock (Fig. 8/Item 3) for the additional handle un-
til it can be moved forwards and backwards without any great resis-
tance. Set the required position and tighten the securing screw again.
5.5 Adjusting the angle of tilt of the guide handle (Fig. 9)
Press the button for the angle of tilt adjustment (Fig. 9/Item K). Now
you can set the long handle to the required tilt. Release the button
and allow the handle to lock into position to fi x the angle of tilt. Three
diff erent locking angles are possible.
5.6. Installing the battery (Fig. 10/11)
Press the side pushlock buttons of the battery pack as shown in Fig.
10 and push the battery pack into the mount provided. When the
battery pack is positioned as in Fig. 11, make sure that the pushlock
buttons latch in place! To remove the battery pack, proceed in rever-
se order.
5.7 Charging the battery (Fig. 12)
1. Take the battery pack out of the equipment. Do this by pressing
the side pushlock buttons.
2. Check that your mains voltage is the same as that marked on the
rating plate of the battery charger. Insert the power plug of the
charger into the mains socket outlet. The green LED will then be-
gin to fl ash.
3. Insert the battery pack into the battery charger.
4. In section „Charger indicator" you will fi nd a table with an explana-
tion of the LED indicator on the charger.
The battery pack can become a little warm during the charging. This
is normal. If the battery pack fails to charge, check:
•
whether there is voltage at the socket outlet
•
whether there is good contact at the charging contacts
Anl_PE_ART_18_Li_Basic_SPK7.indb 263 Anl_PE_ART_18_Li_Basic_SPK7.indb 263
- 263 -
GB
21.01.16 13:58 21.01.16 13:58