Special Settings - tormatic RUN 500 Accu-Set Mode D'emploi

• Special settings

In order to access the menus for the special settings,
keep key pressed for 3 sec until figure 3 is
displayed. Press key to by-pass menu step 3.
Now keep key pressed for 3 sec until figure 5 is
displayed. Press key to by-pass menu steps.
Menu stage 5: The opening force limit
After approx. 2 seconds, the display flashes showing
the set value of the opening force limit. The factory
setting is 4!
The force limit setting can be increased for
decreased via buttons and
value, press button . The display shows "6".
Menu stage 6: The closing force limit
After approx. 2 seconds, the display starts flashing,
and the set value for the closing force limit is
displayed. The factory setting is 4!
The force limit setting can be increased or decreased
via buttons and . After setting the value, press
button . "7" appears in the display.
Finally, check the force settings, and, if necessary,
repeat the setting procedure.
We expressly state that when changes
are made in special menu 6, compliance
with the permitted forces must be stated
by measurement with approved device in
accordance with En12455.
If the force setting is too high, persons may be placed
at risk of injury.
Menu stage 7: Light phases
Keep button pressed until "7" appears in the
display.
Menu value Light phase
_____________________
0 30 s
1 60 s
2 90 s
The factory setting is 0!
Dear customer,
During production the garage door operator
you have purchased has undergone various
checks by the manufacturer to ensure that it is
of impeccable quality. Should this operator or
parts of it prove to be of no use or limited use
as a result of proven material or manufacturing
defects, we shall rectify this, at our discretion,
through free-of-charge repair or replacement.
We shall not accept any liability for damage as
a result of unsatisfactory fitting and
installation, improper putting into service,
incorrect operation and maintenance,
excessive use and overloading as well as any
Retain these installation, operating and maintenance instructions for the full duration of the operator's service life!
Menu stage 8: Door fitting
Press button
Menu value
________________________________
0
1
2
The factory setting is 0!
Menu stage 9: Battery type
Press button
charge control for the battery type used is set in this
menu.
. After setting the
Menu value
________________________________________
0
1
2
3
Types 2 and 4 are already reserved but not yet
released. The factory setting is 0!
Terms of the Guarantee
alterations or modifications carried out to the
operator and accessory parts by the customer.
The same shall also apply for damage incurred
during transit or as a result of force majeure,
external influences or natural wear as well as
special atmospherical stresses. We cannot
accept any liability following alterations or
modifications of functional parts carried out by
the customer. We must be notified of any
defects immediately in writing; on request the
parts in question are to be made available to
us.
. "8" appears in the display.
Closing speed
100%
90%
80%
. "9" appears in the display. The
Battery type
Panasonic LC-CA1215P1
Type 2
Type 3
Type 4
We shall not bear the costs for dismantling
and installation, freight and carriage. If a
complaint is proven to be unjustified, the
customer must bear our costs.
This guarantee is only valid in conjunction
with the signed invoice and commences on
the day of delivery. The manufacturer
guarantees that the product is free of defects.
The warranty is granted for a period of 24
months, in as far as the verification overleaf
has been properly filled out. Otherwise the
warranty shall expire 27 months after the date
of manufacture.
GB