Low Voltage Wire - sistem air FLEXIN Guide D'installation

Low voltage wire

Run low voltage wire to each inlet just as you would in a
standard central vacuum installation.
Connect the two leads from the switch (on the outside of
the valve) to the low voltage wire (fi gure 13).
If you are installing this system in Europe, run the low
voltage wire through the ITCA-type electric sheath (sold
separately), just like any other central vacuum installation
and bring the sheath down over the inlet's wires, into the
dedicated opening (fi gure 14).
Once the low voltage wires are connected, do a conduc-
tivity test before closing wall. We also recommend to per-
form a suction test to make sure that the installation is
sealed properly.
28
Not included.
13
14