Cleaning And Maintenance; Air Filter - Trudell Medical International Ombra Manuel De L'utilisateur

Masquer les pouces Voir aussi pour Ombra:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 12
1. Place the compressor on a clean, flat surface or table top. Ensure there is nothing blocking the
VENTS
on either side of the compressor. Verify that the
2. Read and understand the instructions included with your reusable AEROECLIPSE* XL Breath
Actuated Nebulizer (BAN).
3. Assemble the nebulizer as instructed.
4. Connect one end of the EZ Twist
other end to the
nebulizer may then be placed in the
your treatment as shown in Figure 4.
FIGURE 4
5. Plug the Ombra* Table Top Compressor into an electrical outlet.
6. In a relaxed, comfortably seated position, pick the nebulizer up out of the
the compressor and start your treatment.
7. When your treatment is complete or during a rest in your treatment, the nebulizer may be placed
CUP HOLDER
back in the
NOTE: The compressor should be unplugged when not in use.

CLEANING AND MAINTENANCE

AIR FILTER

Your Ombra* Table Top Compressor is equipped with a special air filter that will slowly change colour
with use. The original filter is bright white, but it will slowly turn grey with use. Your air filter should be
changed every 30 days, or as visual inspection indicates. The compressor should never be used without
an air filter installed.
To change the filter (Figure 5)
AIR FILTER COVER
1. Remove
degrees. Pull the cap and filter cover out.
2. Remove filter from the cover, and dispose of the old filter.
3. Insert a new filter into the cover, then place the
turn clockwise approximately 90 degrees to tighten.
4. Do not over tighten. There will be resistance when the
EN
6
TUBING
AIR OUTLET
on the compressor. Ensure both ends are securely engaged. The
CUP HOLDER
and the compressor switched off.
by holding the cover and turning counterclockwise approximately 90
ON/OFF SWITCH
to the fitting on the bottom of the nebulizer and the
on the compressor until you are ready to start
AIR FILTER COVER
AIR FILTER COVER
is in the 'Off' position.
CUP
HOLDER. Switch on
back into the compressor and
is securely fastened.
AIR

Publicité

Table des Matières
loading

Table des Matières