Color Options - Rockford Fosgate X4.A Mode D'emploi

4. For this example, using the
(down) key, scroll through the sub-
menu until "HIGH PASS" shows next to
"SET:" and then press the Select key.
NOTE: If ALL PASS was set at this point and
the Select key was pressed, the DSP
would have moved to REAR XOVER
and no further adjustment could be
made to FRONT XOVER.
5. After pressing the Select key, the display should now show "FRONT
XOVER FREQ" at top and "SET: 350" with flashing up and down arrows
at the bottom. 350 is the default number.
6. Press the (down) key to scroll down through the numbers until 80
shows next to "SET:". If you go too far, press the
through the numbers. Pressing and holding a key for more than one (1)
second will quickly scroll through the selection.
7. When 80 has been set, press the Select key and the DSP will move to REAR XOVER. The amplifier
Front crossover is now set to High Pass @ 80Hz.
8. Use steps 4 thru 7 to set the REAR XOVER. When it has been set, the DSP will return to the title
screen.
Use the same procedure to set the other features of the TYPE RF amplifier to meet your application.
SAVE YOUR SETTINGS
Once you have completed adjustments to the amplifier that fit your needs, save these settings to one of the
PRESET locations.
NOTE: If you need help or have specific setting procedure questions, contact Rockford Technical Support.
MUTING THE AMPLIFIER
To mute the amplifier outputs, press the
and (down) keys again to un-mute. This will not change any settings in memory.
C O
OLOR PTIONS
Personalize your Type RF amplifier by
changing the top and corner plastics to
different colors. Available through our web
site or local retailer.
The corners can be changed by removing the screw
at the bottom, pull the old corner up and out, install
the new corner, and reinstall the screw.
The top plastic requires you to remove the cover
plate from the amplifier. Do this by removing the
four (4) 3/16" allen screws from each corner.
Remove the screw holding the top plastic in place,
pull the old top up and out, install the new top,
ensure the top fits into the notches at the back, and
reinstall the screw. Reinstall the cover plate and the
four (4) allen screws.
12
(up) or
4
(up) key to scroll up
(up) and (down) keys at the same time. Press the
5-
6
7
Allen
Screw
(up)
Screw