Operation; Adjusting Gain; Adjusting Crossover Frequency; Color Options - Rockford Fosgate Type RF X5.A Mode D'emploi

O
PERATION

ADJUSTING GAIN

To adjust the gain setting, turn the amplifier gains all the way down. Turn the source unit volume up
until distortion is audible and then turn it down a bit until the distortion is inaudible. Next, turn the
amplifier gain setting until once again distortion is audible and then back it down until the distortion
is inaudible. Rockford Fosgate source units do not distort, so the volume can be used at maximum
setting.
NOTE: For a more in depth setting procedure, contact Rockford Technical Support.

ADJUSTING CROSSOVER FREQUENCY

The crossover frequency can be adjusted between 50-250Hz. The crossover is set to LP (Low Pass)
operation only.
Turn the crossover adjustment knob all the way down. With the system playing, turn the crossover
adjustment knob up slowly until the desired crossover point is achieved.
INFRASONIC FILTER
Placing the switch to "ON" engages the infrasonic filter limiting the amount of low frequency
information going to the woofer. Set this to your personal preference while listening to the system
one way, then the other.
C O
OLOR PTIONS
Personalize your Type RF amplifier by
changing the top and corner plastics to
Screw
different colors. Available through our web
site or local retailer.
The corners can be changed by removing the screw
at the bottom, pull the old corner up and out, install
the new corner, and reinstall the screw.
The top plastic requires you to remove the cover
plate from the amplifier. Do this by removing the
four (4) 3/16" allen screws from each corner.
Remove the screw holding the top plastic in place,
pull the old top up and out, install the new top,
ensure the top fits into the notches at the back, and
Allen
reinstall the screw. Reinstall the cover plate and the
Screw
four (4) allen screws.
8