Power Connection - Rockford Fosgate X4.A Mode D'emploi

9. Connect the speakers. Strip the speaker wires 1/2" and insert into the speaker terminal and
tighten the set screw to secure into place. Be sure to maintain proper speaker polarity. DO NOT
chassis ground any of the speaker leads as unstable operation may result.
10. Perform a final check of the completed system wiring to ensure that all connections are
accurate. Check all power and ground connections for frayed wires and loose connections
which could cause problems. Install the fuse into the fuseholder.
NOTE: Follow the diagrams for proper signal polarity.
CAUTION: These amplifiers are not recommended for impedance loads below 2Ω
!
stereo and 4Ω bridged (mono).
NOTE: If only 2-Channels are being used to connect the amplifier ensure the Input Mode is set to
2-In/4-Out and connection is made to the Front Inputs. Otherwise, the Rear Channel output will
not function and settings made to the Rear Channel will not be effective.
Power
Connection
2-Channel Wiring
2-Channel In:
Front and Rear
Bridged
2-Channel In:
Front Stereo and
Rear Bridged
I
NSTALLATION
7