Backup Power; Remote Sensor - Oregon Scientific +ECO RMR331ES Mode D'emploi

BACkUP POwER

1 piece AAA battery
In the case when the rechargeable battery is flat or nearly
flat or when the solar panel has been detached, the AAA
battery can act as backup power supply for the main unit.
. Remove the battery compartment located at the base
of the unit.
2. Insert the battery, matching the polarity.
3. Press RESET after each battery change.
Power adaptor (not included)
The adaptor powers the unit and can also be used for
charging the rechargeable battery. When connected to the
main unit, will be displayed.
NOTE
The main unit and adaptor should not be exposed to
wet conditions. No objects filled with liquid, such as vases,
should be placed on the main unit and adaptor.

REMOTE SENSOR

To set up the remote sensor:
. Slide open the battery compartment.
2. Slide channel switch to select a channel (, 2, 3).
3. Insert the battery, matching the polarities.
4. Press RESET after each battery change.
5. Close the battery compartment.
6. Press and hold SEARCh for 2 seconds to initiate a
sensor search.
NOTE
Use alkaline batteries for longer usage and
consumer grade lithium batteries in temperatures below
freezing.
The remote sensor reception icon will show the following
status:
iCONS
TiP
Ideal placements for the sensor would be in any
location on the exterior of the home at a height of not more
than .5 m (5 ft) and which can shield it from direct sunlight
or wet conditions for an accurate reading.
6
MEANiNG
Main unit is searching
for sensor(s)
A sensor channel has
been found
No sensor found