Pattfield Ergo Tools PE-ART 18 Li Traduction De La Notice Originale page 272

5.9 Charging the battery (Fig. 15)
1. Take the battery pack out of the equipment. Do this by pressing
the pushlock buttons.
2. Check that your mains voltage is the same as that marked on the
rating plate of the battery charger. Insert the power plug of the
charger (10) into the mains socket outlet. The green LED will then
begin to fl ash.
3. Insert the battery pack (11) into the battery charger (10).
4. In section „Charger indicator" you will fi nd a table with an explana-
tion of the LED indicator on the charger.
The battery pack can become a little warm during the charging. This
is normal. If the battery pack fails to charge, check:
•
whether there is voltage at the socket outlet
•
whether there is good contact at the charging contacts
If the battery pack still fails to charge, take
•
the charging unit
•
and the battery pack
to your Hornbach store.
GB
To ensure that the battery pack provides long service, you should
take care to recharge it promptly. You must recharge the battery pack
when you notice that the power of the cordless grass trimmer drops.
Never fully discharge the battery pack. This will cause it to develop a
defect.
5.10 Battery capacity indicator (Fig. 16)
Press the switch for the battery capacity indicator (Item C). The batte-
ry capacity indicator (Item B) shows the charge status of the battery
using 3 LEDs.
All 3 LEDs are lit:
The battery is fully charged.
Anl_PE_ART_18_Li_SPK7.indb 272 Anl_PE_ART_18_Li_SPK7.indb 272
- 272 -
19.09.2016 09:38:35 19.09.2016 09:38:35