Pattfield Ergo Tools PE-ART 18 Li Traduction De La Notice Originale page 271

5.3 Inserting the blade (Fig. 7)
Place the larger opening of the blade (Item 9) in the blade mount (A)
on the blade head (Item 7) and pull it outwards in the direction of the
arrow until the blade clicks into place as shown in Fig. 22.
5.4 Height adjustment (Fig. 8)
Undo the union nut (Item 5) until the grass trimmer handle can be
moved in and out freely. Now set the required working height (Fig.
9) and secure the handle in this position by tightening the union nut
again.
5.5 Fitting the additional handle (Fig. 10)
Fit the additional handle to the mount provided, paying attention to
the teeth (Item I & II). Then secure the additional handle with the help
of the screw and the adjustment lock provided. Make sure that the
compartment for the spare blades faces the top of the equipment.
5.6 Adjusting the additional handle (Fig. 11)
Undo the adjustment lock (Item 3) for the additional handle until it can
be moved forwards and backwards without any great resistance. Set
the required position and tighten the securing screw again.
5.7 Adjusting the angle of tilt of the guide handle (Fig. 12)
Press the button for the angle of tilt adjustment (Item K). Now you can
set the long handle to the required tilt. Release the button and allow
the handle to lock into position to fi x the angle of tilt. Three diff erent
locking angles are possible.
5.8 Installing the battery (Fig. 13/14)
Press the side pushlock buttons of the battery pack as shown in Fig.
13 and push the battery pack into the mount provided. When the
battery pack is positioned as in Fig. 14, make sure that the pushlock
buttons latch in place! To remove the battery pack, proceed in rever-
se order.
Anl_PE_ART_18_Li_SPK7.indb 271 Anl_PE_ART_18_Li_SPK7.indb 271
- 271 -
GB
19.09.2016 09:38:35 19.09.2016 09:38:35