Potential Problems And How To Tackle Them - Wamsler TRENDY 6 Mode D'emploi

1.6 Potential problems and how to tackle them

Kind of operating prob-
lem
Odour formation
Too little heating per-
formance
Chimney fire may occur upon the improper cleaning of the chimney, the use of
inappropriate fuels (e.g. excessively wet wood) or the inadequate setting of the
burning air. In such cases, close the burning air at the fire, and call the fire service.
Possible reasons
Curing of the applied preven-
tive lacquer.
Steaming oil remains.
•
We chose too little per-
formance
•
Chimney draught is slight
•
Too long and leaky
smoke tube
•
Leakage at the door
glass
•
Usage of wet wood.
Actions to be in chimney fire
Never try to extinguish the fire with water!
Solution
Operate the fire-place on a
low heating level according to
the instructions manual for a
few hours. Then heat up for
maximal performance for a
few hours.
•
•
•
•
•
•
32
Have the heating re-
quirement of the room
examined by an expert
Chimney draught shall
be at least 12 Pa, max.
for a short time 18 Pa
Check the tightness of
your chimney and also
that the doors of other
fire-places leading to the
same chimney are
closed and sealed prop-
erly. Make sure that the
chimney-cleaning joints
are sealed properly.
All the smoke tube joints
must be well sealed and
fireproof-isolated
Check the sealing, close
the door properly. May
have to have the tighten-
ing flap renewed.
Use well dried wood
only.