Publicité
Les langues disponibles
Les langues disponibles
User Manual
Product Overview
Extender Splitter, Transmitter
▪
Power LED: Indicates power of the transmitter.
▪
Cat Out 1-4: Connect to the receiver units using Cat.6 or above cable.
▪
PoC LED: Indicates PoC is supplying power to the connected receiver over Cat.6 cable.
▪
HDMI Out: Connect to a local HDMI display, or alternatively connect up to 2 further 38155 units for
larger scale distribution.
▪
HDMI In: Connect to an HDMI source device using HDMI cable.
▪
IR Out: Transmit IR control to the connected display using the included IR emitter cable.
▪
Update: Reserved for future use.
▪
12VDC: Connect and secure the included power supply.
▪
Power Switch: Push to manually switch the system on or off. "-" for On, "O" for Off.
Receiver
▪
HDMI Out: Connect to an HDMI display
▪
IR In: Receive IR control from an IR remote using the included IR receiver cables.
▪
Cat In: Connect to the transmitter unit using Cat.6 or above cable.
▪
Power LED: Indicates power of the receiver.
Installation
Please follow the below instructions for installation.
Lindy advises using high-quality HDMI cables up to 2m in length on the input, and 2m in length on the
output. Cat.5e cabling can also be used however this will impact the maximum distance possible, therefore
Cat.6 cable or above is recommended for use. Please ensure all devices are switched off prior to
installation.
1. Connect an HDMI display to the required receiver unit using HDMI cable.
2. Connect a Cat.6 or above network cable to the Cat In port of the receiver unit.
3. Connect the opposing end of the Cat.6 cable to one of the 4 Cat Out ports of the splitter.
4. For local HDMI distribution, connect an HDMI display to the local HDMI Out port of the splitter unit.
If cascading, please connect an additional splitter extender to the HDMI Out port of the splitter unit
and follow the above steps regarding connecting receivers. Repeat the process again for
connecting a third splitter extender.
5. Connect an HDMI source device to the HDMI In of the splitter unit.
6. Connect the multi-country power supply to the DC jack of the splitter unit and plug into a mains
socket.
7. Switch on all devices. The Power LED of the splitter and receiver units will illuminate once power
has been supplied. Power is provided to the receivers over the network cable using PoC.
8. For additional infrared remote signal functionality, connect the included IR Extension Cables to the
splitter and receiver units, using the IR emitter cable with the IR Out port on the splitter and the IR
receiver with the IR in port of the receivers. Please ensure the emitter cable is in front of the IR port
that will be controlled, while the IR receivers are in line of sight of the IR remote.
English
Publicité
