Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Installing or removing driver bit or
socket bit
12 mm
(15/32")
Use only the driver bit or socket bit shown in the figure.
Do not use any other driver bit or socket bit.
1.
To install the bit, pull the sleeve in the direction of
the arrow and insert the bit into the sleeve as far
as it will go. Then release the sleeve to secure the
bit.
1
► 1. Bit 2. Sleeve
To remove the bit, pull the sleeve in the direction of the
arrow and pull the bit out firmly.
NOTE:
•
If the bit is not inserted deep enough into the
sleeve, the sleeve will not return to its original
position and the bit will not be secured. In this
case, try re-inserting the bit according to the
instructions above.
9 mm
(3/8")
2
OPERATION
The tool can be used in two ways; a straight type and a
pistol type which is selectable according to the condi-
tions of workplace and screwdriving.
CAUTION:
•
When bending the tool to use in the pistol type
or straightening to use in the straight type, do
not hold the bendable part of the tool. Failure to
do so may cause your hand and fingers to be
pinched and injured by this part.
Hold the tool firmly and place the point of the driver bit
in the screw head. Apply forward pressure to the tool to
the extent that the bit will not slip off the screw and turn
the tool on to start operation.
The proper fastening torque may differ depending upon
the kind or size of the screw/bolt, the material of the
workpiece to be fastened, etc. The relation between fas-
tening torque and fastening time is shown in the figures.
6 ENGLISH
Publicité
Table des Matières
