Drying Rack - GE Spacemaker DSXH43 Manuel De L'utilisateur

About your dryer features.
CYCLE SIGNAL
OFF ON
CYCLE SIGNAL
QUIET LOUD
OFF
Light
cover
Pry with
flat blade
Light
screwdriver
housing
Cycle Signal
When the signal is on it will sound just
before the end of the cycle to remind you
to remove the clothes. On some models
the signal can be set at OFF (no sound) or
from QUIET to LOUD.
If the dried load cannot be removed
promptly during the AUTOMATIC PERM
PRESS & DELICATES cycle, the Cycle
Selector will advance to the EXTRA CARE
setting. Unheated tumbling continues
during EXTRA CARE for 40 minutes to
help reduce wrinkling. When the CYCLE
SIGNAL is on, it will sound briefly every
five minutes as a reminder to remove
the load.
Replacing the Dryer Light Bulb
WARNING: To reduce the risk of
electric shock, disconnect this
appliance from the power supply
before attempting any user
maintenance. Turning the controls
to the OFF position does not
disconnect this appliance from the
power supply.
The dryer light is located above the dryer
door opening.
Before replacing the light bulb, be sure to
unplug the dryer power cord or disconnect
the dryer at the household distribution
panel by removing the fuse or switching
off the circuit breaker.

Drying Rack

A handy drying rack may be used for drying
articles such as stuffed toys, pillows or
washable sweaters.
Remove the lint screen.
1
Place the front bar under the lip of the
2
lint screen opening.
When items are dry, remove the rack
3
and replace the lint screen. DO NOT
OPERATE THE DRYER WITHOUT THE LINT
SCREEN IN PLACE UNLESS THE DRYING
RACK IS IN PLACE.
NOTE:
If items are removed before the end of
the cycle, turn the CYCLE SELECTOR knob
to OFF.
Remove garments promptly at the sound
of the signal. Place clothes on hangers
so wrinkles won't set in.
Use the Cycle Signal especially when
drying fabrics like polyester knits and
permanent press. These fabrics should
be removed so wrinkles won't set in.
To replace the dryer light:
Using a small flat blade screwdriver,
1
pry the bottom of the light cover out
and off the light housing.
2 Unscrew the bulb when cool and
replace it with an appliance bulb of
the same or lower wattage.
Snap the light cover back on the light
3
housing.
NOTE:
The drying rack must be used with the
TIMED DRY cycle.
Do not use this drying rack when there
are other clothes in the dryer.
7