Ice Maker And Storage Bin - Maytag MSC21C6MFZ Guide D'utilisation

Ice Maker and Storage Bin

Allow 24 hours to produce the first batch of ice. Discard the first
■
three batches of ice produced.
The quality of your ice will be only as good as the quality of the
■
water supplied to your ice maker. Avoid connecting the ice maker
to a softened water supply. Water softener chemicals (such as salt)
can damage parts of the ice maker and lead to poor quality ice. If
a softened water supply cannot be avoided, make sure the water
softener is operating properly and is well maintained.
Do not use anything sharp to break up the ice in the storage bin.
■
This can cause damage to the ice container and the dispenser
mechanism.
Do not store anything on top of or in the ice maker or storage bin.
■
Style 1
Turning the Ice Maker On/Off:
The On/Off switch, located on the left wall of the freezer door, can only
be accessed when the ice storage bin has been removed. See the
following section for bin removal instructions.
ON
OFF
To turn on the ice maker, flip the switch to the On (up) position.
■
To manually turn off the ice maker, flip the switch to the Off (down)
■
position.
NOTE: The ice maker has an automatic shutoff to keep the storage bin
from overfilling during normal operation. As ice is made, the ice cubes
will fill the ice storage bin and the ice cubes will raise the shut-off arm to
the Off (arm up) position. When the storage bin is at full capacity, the
ice maker will automatically stop ice production, but the ice maker On/
Off switch will remain in the On (up) position.
Ice production OFF
(Shut-off arm up)
Ice production ON
(Shut-off arm down)
Removing and Replacing the Ice Storage Bin:
1. Press down the release lever and tilt the bucket outward. Use both
hands to hold the base of the storage bin, then lift it up and out.
NOTE: It is not necessary to flip the ice maker On/Off switch to the
Off (down) position when removing the storage bin. The storage bin
sensor, located on the right wall of the freezer door, stops the ice
maker from producing ice if the door is open or the storage bin is
removed.
A
B
A. On/Off switch
B. Storage bin sensor
2. Replace the bin by sliding it onto the door, then tilting it back into
an upright position. The release lever will click when the bin is
securely in place.
Style 2
Turning the Ice Maker On/Off:
To turn nn the ice maker, simply lower the wire shut-off arm.
■
To manually turn off the ice maker, lift the wire shut-off arm to the
■
Off (arm up) position and listen for the click. Ice can still be
dispensed, but no more can be made.
NOTE: The ice maker has an automatic shutoff to keep the storage bin
from overfilling during normal operation. As ice is made, the ice cubes
will fill the ice storage bin and the ice cubes will raise the wire shut-off
arm to the Off (arm up) position. Do not force the wire shut-off arm up
or down.
Removing and Replacing the Ice Storage Bin:
1. Pull the covering panel up from the bottom.
2. Lift the wire shut-off arm so it clicks into the Off (up) position.
A
A. Release lever