The Ice Dispenser; The Dispenser Light; The Dispenser Lock - Maytag MSC21C6MFZ Guide D'utilisation

If the flow of water from the dispenser decreases, it could be
■
caused by low water pressure.
■
With the water filter removed, dispense 1 cup (237 mL) of water.
If 1 cup of water is dispensed in 8 seconds or less, the water
pressure to the refrigerator meets the minimum requirement.
If it takes longer than 8 seconds to dispense 1 cup of water, the
■
water pressure to the refrigerator is lower than recommended.
See "Water Supply Requirements" (in the User Instructions or
the Installation Instructions and Owner's Manual) or "Problem
Solver" for suggestions.
To Dispense Water:
1. Press the Dispense Type arrows on the dispenser control panel,
until "Water" is selected.
2. To dispense water, press a sturdy glass against the dispenser pad
or press the Water button. Hold the glass close to the water
dispenser spout to ensure that the water dispenses into the glass.
A. Water dispenser spout
3. To stop dispensing, remove the glass from the dispenser pad or
release the Water button.

The Ice Dispenser

Ice dispenses from the ice maker storage bin in the freezer when the
dispenser pad is pressed. To turn off the ice maker, see "Ice Maker and
Storage Bin."
Your ice maker can produce both crushed and cubed ice. Before
dispensing ice, select which type of ice you prefer by pressing the
Dispense Type arrows.
The display screen indicates which type of ice is selected.
CRUSHED
For crushed ice, cubes are crushed before being dispensed. This may
cause a slight delay when dispensing crushed ice. Noise from the ice
crusher is normal and pieces of ice may vary in size. When changing
from crushed to cubed, a few ounces of crushed ice will be dispensed
along with the first cubes.
A
CUBED
To Dispense Ice:
1. Make sure the desired type of ice is selected. To switch between
cubed and crushed, press the Dispense Type arrows.
WARNING
Use a sturdy glass when dispensing ice.
Failure to do so can result in cuts.
2. To dispense ice, press a sturdy glass against the dispenser pad
or press the Ice button. Hold the glass close to the ice guide to
ensure that the ice dispenses into the glass.
IMPORTANT: You do not need to apply a lot of pressure to the pad
in order to activate the ice dispenser. Pressing hard will not make
the ice dispense faster or in greater quantities.
3. To stop dispensing, remove the glass from the dispenser pad or
release the Ice button.
NOTE: Ice may continue to dispense for several seconds after
removing the glass from the pad. The dispenser may continue to
make noise for a few seconds after dispensing.

The Dispenser Light

When you use the dispenser, the light will automatically turn on. If you
want the light to be on continuously, you may choose either ON or DIM.
ON: Press LIGHT to turn the dispenser light on. "On" will appear on the
display screen.
DIM: Press LIGHT a second time to select Dim mode. "Dim" will appear
on the display screen. The dispenser light will remain on but at a lower
intensity.
OFF: Press LIGHT a third time to turn the dispenser light off.
The dispenser lights are LEDs that cannot be changed. If it appears
that your dispenser lights are not working, see "Problem Solver" for
more information.

The Dispenser Lock

The dispenser can be turned off for easy cleaning or to avoid
unintentional dispensing by small children and pets.
NOTE: The lock feature does not shut off power to the refrigerator, to
the ice maker, or to the dispenser light. It simply deactivates the
controls and dispenser pad. To turn off the ice maker, see "Ice Maker
and Storage Bin."
Press and hold LIGHT for 3 seconds to lock the dispenser.
■
"Dispenser Locked" will appear on the display screen.
Press and hold LIGHT a second time to unlock the dispenser.
■
Cut Hazard
A
A. Ice guide