Functions - Trotec BD10 Notice D'emploi

the indication for continuous measuring appears on the display. Press
the key again to cancel this procedure. The procedure is terminated
automatically after 100 measurements in continuous measuring mode.

5. Functions

Addition / Subtraction
Distance measurement
Adding the second value to the first value. Press the key
the second value. The result from the addition of these two values appears
automatically. Subtracting the second value from the first value. Press
the key to see the result. The second value always appears in the
second line, the result in the bottom line.
The last step is cancelled.
Return to the individual measuring mode.
EN
Area measurements
Press the relevant key
appears on the display.
Press the key
Press the key
the width).
The meter calculates the area independently after the second press of the
key and presents it as a value in the bottom line of the display. The last
measuring value is displayed in the second line.
, to see
Volume measurements
Press the key for this measuring mode 2x
appears on the display. The side that is to measured starts to blink on
the display: Press the key
Press the same key
third time to measure the width as well as the height. The meter calculates
the volume and presents the result as a value on the display. The last
measuring value is not displayed.
Operating Manual – Laser Distance Meter BD 10
once. The symbol for the measuring mode
to start the first measurement (e.g. the length).
again to carry out the second measurement (e.g.
until the relevant information
to activate the measurement.
again to measure the length and a second and a
B - 6