Helpful Hints - Porter Cable PCE605 Manuel D'instructions

DEPTh GUIDE
This feature allows you to precisely cut material at a specified depth.
• To use the depth guide, insert the guide as shown in figure 10 into the front slot on the
guide block.
• Adjust the length of the guide by pulling out or pushing inward to achieve the desired
cut depth as shown in figure 11.
• Secure the guide in place by turning the depth/cut adjustment knob clockwise. To
release the guide turn the depth/cut adjustment knob counterclockwise.
CUT GUIDE
This feature allows you to more accurately track a marked cut line.
• To use the cut guide, insert the guide as shown in figure 12 into the slots on the left and
right sides of the guide block.
• Adjust the length of the guide by pulling out or pushing inward to achieve the desired
length as shown in figure 13.
• Secure the guide in place by turning the depth/cut adjustment knob clockwise. To
release the guide turn the depth/cut adjustment knob counterclockwise.
WARNING:
cleaner because sparks are generated. Wear safety glasses and a dust mask. Due to the danger
of fire, do not use your sander to sand magnesium surfaces. Do not use for wet sanding.
NOTE: Do not rest fingers on platen during use. Move it in long sweeping strokes across the
surface, letting it do the work. Light pressure is all that is required for sanding. Excessive pressure
will slow the tool and produce inferior results. Check your work often, product is capable of
removing material rapidly. Excessive force will reduce the working efficiency and cause motor
overload. Replacing the sanding sheet regularly will maintain optimum working efficiency.
NOTE: Always ensure the work piece is firmly held or clamped to prevent movement. Any
movement of the material may affect the quality of the sanding finish.
• Always ensure the work piece is firmly held or clamped to prevent movement. Any
movement of the material may affect the quality of the cutting or sanding finish.
• Do not start sanding without having the sandpaper attached to sanding platen.
• Use coarse grit paper to sand rough surfaces, medium grit for smooth surfaces and
fine grit for the finishing surfaces. If necessary, first make a test run on scrap material.
• Excessive force will reduce the working efficiency and cause motor overload.
Replacing the accessory regularly will maintain optimum working efficiency.
• Do not allow the sandpaper to wear away, it will damage the sanding pad.
• If the tool overheats, especially when used at low speed, set the speed to maximum
and run it with no load for 2-3 minutes to cool the motor. Avoid prolonged usage at very
low speeds. Always keep the blade sharp.
10
12
SANDING
Fire hazard. When working on metal surfaces, do not use a vacuum

hELPFUL hINTS

11
13
9