Porter Cable PCE605 Manuel D'instructions page 7

• Slide the accessory between the shaft and the accessory holder making sure the
accessory engages all eight pins on the holder and is flush with the shaft (figure 3).
• Release the accessory clamp lever.
• Some accessories, such as scrapers and blades can be mounted at an angle if
required as shown in figure 4.
3
INSTALLING/REMOVING DEPTh/CUT BLOCk
The depth/cut guide allows you to precisely cut
material at a specified depth and more accurately
track a marked cut line.
• Attach the depth/cut block by inserting the tabs
on the guide into the slots on the main body of the
PCE605 as shown in figure 5.
• Secure the block to the main body with the supplied
screw and tighten with the supplied hex wrench as
shown in figure 6.
INSTALLING/REMOVING
SANDING ShEETS
A diamond shaped platen uses a hook and loop
adhesion system to attach the sanding sheets. The
platen allows you to use it on large flat surfaces and
tight spots or corners.
• Attach the sanding platen as described under
"Installing/Removing Accessories".
• Align the edges on the sanding sheet, with the edge
of the sanding platen and press the sanding sheet
onto the platen as shown in figure 7.
• Firmly press the base with the sanding sheet
attached against a flat surface and briefly switch the tool on. This provides for good
adhesion between the platen and the sanding sheet and also helps to prevent
premature wear.
• When the tip of the sanding sheet becomes worn, detach the sheet from the platen,
rotate and reapply.
4
5
6
7
7