Axis Q87-E Serie Guide D'installation page 8

Page 8
Install the Bracket (sold separately)
1. Prepare a wall, parapet or pole for installation of the selected bracket (sold separately). See www.axis.com for
information on available mounting accessories.
2. Route the network, power and, if applicable, illuminator cables through the bracket. Leave approximately
50 cm (11.8") of cable for connecting the base.
Due to local regulations or the environmental and electrical conditions in which the product is to be used,
a shielded network cable (STP) may be appropriate or required. Any network cables that are routed in out-
door environments or similar shall be shielded (STP) and intended for their specific use. Make sure that the
network switch is properly grounded. See Electromagnetic Compatibility (EMC) for regulatory requirements.
50 cm
3. Install the selected bracket. Make sure that the screws and plugs are appropriate for the material (e.g. wood,
metal, sheet rock, stone). Make sure that the bracket is secured properly and that the material is strong
enough to support a weight of 35 kg (77.2 lb.).
• Assemble the product in an upright position. Do not install the product upside down.
• When attaching the bracket to a concrete surface, use dowel pins with a traction torque rating of
 300 dN.
• When attaching the bracket to a metal surface, use screws with a diameter of at least 8 mm.
1
50 cm
3
1
2
1 Network, power and illuminator cables
2 Wall bracket
3 Column bracket
AXIS Q87-E Installation Guide