Axis Q87-E Serie Guide D'installation page 17

AXIS Q87-E Installation Guide Page 17
Configuration
For information about how to assign an IP address and gain access to the product, see Access the Video Stream, on
page 18 and the Installation and Management Software CD.
PTZ
The PTZ functionality is controlled through the network camera. The PTZ controls will be available from the Live
View page in the network camera's web pages after enabling the PTZ functionality. See the User Manual, available
at www.axis.com
Day/Night Sensor
The day/night sensor is attached to the power supply (sold separately).
The product is configured in the factory for optimal performance in a range of conditions. However, settings can
be adjusted to suit specific conditions on site.
To adjust the sensitivity of the day/night sensor, turn the potentiometer until it reaches the desired threshold.
Turn the potentiometer clockwise to increase the threshold and advance the switch to night mode. Turn the
potentiometer counterclockwise to decrease the threshold and delay the switch to night mode. The switch to
night mode will activate the illuminators (sold separately).
De-icing
The product's automatic de-icing process starts when the air temperature is below 0 °C (32 °F) required that the
product is switched on. The de-icing process ensures that the product works properly even at low temperatures.
The de-icing period lasts 90 minutes and during this period both cameras are turned off.